Wanted 600 carb flywheel rotor Would anyone have, or know of anyone who has a 600 carb flywheel rotor to sell? Thanks |
Do you have a pic of the part you need |
I haven't had chance to get to it to take a pic. Its the magnetic rotor that spins inside the stator. The link below shows it, its in the bottom left corner of the drawing. Thanks http://www.stein-dinse.biz/eliste/el...6ebeb36g&lg=de |
I'll have a check to see what I have, similar to the early 748 and 916 but narrower if I recall correctly but without measurements it is probably hard to tell one from the other |
Yes you're right they are smaller. I'll look to see if I can find the dimensions again. Thanks for your help |
What year 583 is it? Marcus Dealey may have an early one in a box with the rest of a dismantled engine. |
The engine is a 95 model. Thanks |
Rotor size. OD 76mm ID 19mm Depth 38mm Approx. |
I think it is the depth that is the dimension that varies between the models I will see what I have |
That would be great, I'm really keen to get back on it while the weathers still good. Thanks |
Checked my Garage, my home workshop and the unit and the only early one I can find is to deep at 47mm, probably a 748 or 916 one Not sure if any of the Desmo Due racers have one |
When fitting the rotor back on the crank after engine rebuild on the race bikes, do you always fit the woodruff key or just torque up the nut to hold it?? Reason I ask is I have been told to leave it out as that's what does the damage if the nut backs off. |
All times are GMT +1. The time now is 21:58. |
Powered by vBulletin 3.5.4 - Copyright © 2000 - 2024, Jelsoft Enterprises Ltd.
© Ducati Sporting Club UK