2014 Multi Exhaust header gasket - which way round? Hi, Some help needed here. I am just fitting a full term I system to my multi and in the process of removing the old exhaust I dislodged the header gasket. It has a raised dish surface on one side and a corresponding Hollow on the other side. Which way round do I fit it? Cheers |
I can't recall, are both surfaces the gasket mates against flat?.....if so it doesn't matter - ideally the gaskets should be replaced but if this is the first time the headers have been removed you should be ok. Edit: just checked the manual, no reference to the gaskets being used in any particular orientation. Cheers Andy www.MotorcycleInfo.co.uk and www.MTS1200.info |
Hi Andy, Thanks for posting! In the end I followed the orientation in the photo. Off to get the ECU mapped by Wilf @ Motorapido tomorrow. I cannot wait to see what the bike rides like after! Cheers Trev |
Do let us know ;-) BTW....there's a very active MTS12 owners section here: www.ducatiforum.co.uk Cheers Andy www.MotorcycleInfo.co.uk and www.MTS1200.info |
All times are GMT +1. The time now is 17:16. |
Powered by vBulletin 3.5.4 - Copyright © 2000 - 2024, Jelsoft Enterprises Ltd.
© Ducati Sporting Club UK