adjusting rear brake..
 

just fitted some rear sets, see below picture




2 questions:

1) red arrow - should this bolt be tight?

2) green arrow - I have very little brake pedal before its on, and have to lift the pedal to get it back so its using all the travel, how can I adjust this out?

1- Yes

2 - undo the locknut on the pushrod, screw the pushrod into the linkage and lock it up. You're basically putting clearance between the pushrod and the head of the brake cylinder piston.

thanks, I'll try that tomorrow.

fitting the return spring would have helped :rolleyes:

all done now, cant wait to try them out - I've got a few mm of front tyre to scrub in!! :lol:

Ducatis have a rear brake :puzzled:

I just replaced my rear disc as it was so rusty it looked bad :lol:

am I alone in always havijng had a good rear brake on a dook?! without the return spring this baby was a one toe effort!