749 54mm termis, clearance to 2004 swing arm?
 

Hi
anyone got any photos they could mail me showing the gap between the pipe and the swing arm. Have got about 3mm, seems a bit tight, and I had to jiggle the end can into place. Am a bit worried it not quite set as it should be, and maybe under a bit of tension. Dont want it splitting. Any tips, phtos etc much appreciated

cheers

D

They are all like that sir.....................try it with a 57mm!!!!!

57 = fag paper or a slightly smoother and more silvery swingarm on the weld :D :D I'd take photos but there is no gap to see.

54, should be easy, 3mm is loads of clearance :) watch the lower rear right hand fairing don't touch the pipe, it melts the fairing :D

sounds like a challenge to me!

just smack the pipe with a brick, there'll be loads a room ;)