Hello, I fitted a Discacciati master and calipers on my 748 a few weeks ago with Hel twin lines. I made a small alu. 1 inch bracket which attaches to one of the front bolts on the clip-on clamp and used a spacer and rubber washer to attach the reservoir and give it some cushioning. I bent the bracket to keep the reservoir as horizontal as poss. There were some variable pressure issues to start with that I think were to do with a warped disc but works great now, and the only clearance issue is the lines cutting into the foam around speedo/rev counter at full lock. I'll post a pic if I can find a battery for my camera. BTW tried to fit a 749/999 radial master, and unless I'm missing something, it was never going to go on; the master came up against the clip-on clamp about an inch too far down the bar, pushing the throttle grip well over the end of the clip-on. |