| From the manual (may help)
In the event of replacement of one or
more components of the immobilizer
system (e.g. the black keys, the
decoder, or the engine control unit),
the parts in question must be
programmed. To perform this
operation, proceed as follows:
- check that the motorcycle battery
terminals are correctly connected
and that the battery is in perfect
condition.
- Prepare the red key and the black
keys.
- Insert the red key (2) in the ignition
switch (3).
- Turn the key to the ON position to
switch on the instrument panel.
The instrument panel multifunction
display will show the CODE
symbol, the number of keys
inserted (“1” in this case) and
start a countdown from 30 to 0.
Note: before performing this
action ensure that the ignition
switch remains in the OFF position
for at least thirty seconds.
- Check that the countdown has
started and turn the key to OFF
before it terminates (around
three seconds).
- Remove the red key within 15
seconds, insert a black key (4)
and turn the switch to ON. Display
will show the number of keys
inserted (“2” in this case) and
start a countdown from 30 to 0.
- Check that the countdown has
started and turn the key to OFF
before it terminates.
- Remove the black key within 15
seconds, insert another black key
(5) and turn the switch to ON.
Display will show the number of
keys inserted (“3” in this case) and
start a countdown from 30 to 0.
- Check that the countdown has
started and turn the key to OFF
before it terminates.
- Remove the black key within 15
seconds, insert the red key again
and turn the switch to ON. The
display will show the number of
keys inserted (“4” in this case) and
start a countdown from 30 to 0.
- Check that the countdown has
started and turn the key to OFF
before it terminates. If the
programming sequence has
terminated successfully, the led (A)
on the instrument panel will flash.
At this point the two black keys and
the instrument panel decoder have
been successfully programmed.
Continue the procedure as follows:
- turn the ignition to ON with the red
key within 15 seconds. The CODE
symbol on the display will switch off.
- Leave the key in the ON position
for at least 5 seconds and no
more than 15 seconds, to allow
the data to transfer from the
decoder to the engine ECU and
then turn the key to OFF.
- Wait for 10 seconds, then turn the
ignition switch to ON again.
The programming procedure is now
terminated. The immobilizer system
has been completely programmed.
Even if you need to program only
one component of the immobilizer
system, always run the entire
procedure. At the end of the
procedure, check that the engine
can be started with the black keys.
Warning
If display shows the message
“OFF” during the procedure, this
indicates that the programming
routine has been aborted. Repeat
the procedure from the beginning.
To ensure that the immobilizer is
correctly programmed, you must
scrupulously observe the timings
and other conditions indicated.  |