| Thanks for the replies guys. The spacer on the LHS is in place, taper facing in towards sprocket carrier. The long spacer between the two bearings is in place. On Douglas 851 pictures, the bearing is shown flush with the end of the hub. Comparing that to mine (see pictures) my bearings are approx. 4mm in the hub ?! Douglas851 - can you see the number on the bearings and let me know ? The bearings i have in are marked 6203 which is 40mm OD, 17mm ID and 12mm thick. However, a 62203 bearing is 40mm OD, 17mm ID and 16mm thick !! I'm assuming the dealer has read the nos. incorrectly and put a thinner bearing in, which causes the wheel to lock up. I've contacted the dealer to see if he still has the old bearings in the rubbish bin so i can check the numbers......... |