During the winter months I am going to strip my bike right down in order to get the frame and swingarm powder coated so I'm after a little advice from anyone who may have done this before???
What I would like to know is whether there is a preferred process in stripping the bike i.e. should I remove certain parts in a particular order which would then make the overall process easier?
Also for someone reasonably competent albeit no mechanic how long is this process likely to take?
What are the best methods of recording what parts go back where etc, etc?
I have got a mate who will be helping me who is again not a mechanic but does a lot of his own servicing work etc himself so we are not total novices as such.
Any advice would be gratefully recieved.
Regards Frazelli
