Assuming the original clocks are one the bike, press and hold the left button on the clocks whilst switching the ignition on. This will bring up the EFI fault code. ERROR CODES 1.1 = Throttle Position Sensor (TPS) Disconnected 1.2 = Throttle Position Sensor (TPS) short circuit to earth 2.1 = Pressure Sensor short circuit to power supply 2.2 = Pressure Sensor shorted to earth 3.1 = Water Temp Sensor shorted to power supply 3.2 = Water Temp Sensor shorted to earth 4.1 = Air Temp Sensor shorted to power supply 4.2 = Air Temp Sensor Shorted to earth 5.1 = Battery Hi 5.2 = Battery Lo 10.1 = Horizontal Coil shorted to power supply 10.2 = Horizontal Coil shorted to earth 11.1 = Vertical Coil shorted to power supply 11.2 = Vertical Coil shorted to earth 12.1 = Inj1 shorted to power supply 12.2 = Inj1 shorted to earth 13.1 = Inj2 shorted to power supply 13.2 = Inj2 shorted to earth 14.1 = Inj3 shorted to to power supply 14.2 = Inj3 shorted to earth 15.1 = Inj4 shorted to powersupply 15.2 = Inj4 shorted to earth 16.0 = Pump Relay 17.1 = L/H Fan shorted to power supply 17.2 = L/H Fan shorted to earth 18.1 = R/H Fan shorted to power supply 18.2 = R/H Fan shorted to earth 19.1 = Starter Solenoid shorted to power supply 19.2 = Starter Solenoid shorted to earth 30.0 = ROM/Eprom error 34.0 = Signal Panel Sensor 36.0 = Speed sensor 37.0 = Immobiliser (transponder) 37.1 = Immobiliser (antenna) 37.2 = Immobiliser (instrument panel serial driver) 37.3 = Immobiliser (serial cable disconnected) 37.4 = Immobiliser (ccm serial drive) 37.5 = Immobiliser (key not recognised) 37.6 = Can Line error |