View Single Post
  #3  
Old 13-Nov-2012, 12:57
Cranker V2's Avatar
Cranker V2 Cranker V2 is offline
Registered Forum User
500SD
Bikes: Class A 620ssie #71 - 853 R/RS Dry - 748sp Wet
 
Posts: 725
Join Date: Nov 2009
Mood: Green with envy
A 916/748 top fairing bracket with 4 spacers to eneable you to bolt it to the headstock of the SS. TYou will have to elongate the mounting holes in the bracket to get the correct centrtes for the SS headstock.

Offer up the Full fairing complete, and duct tape / suspend in place. Get the rear of the fairing as high up as you can - you may have to cut out for the exhaust to clear. Mark and drill holes for upper fairing dzus fasteners. Fit em.

Mark and drill holes for sides (use the exisitng SS mounting points) you may have to squeeze in the sides a bit - the 916 was a couple of inches wider.

There ya go. Well, maybe adding a bracket off the rear brake pedal mounting blts to stop the belly pan flopping around would be sensible.
Quote+Reply