[Rushjob]

OK then, the fairing mods..
As mentioned there is an excellent source of info on the ST user group on Yahoo which can be used.
The problem I had with this method was that it was too complicated & replaced fasteners that for my needs didn’t really need touching.
I wanted a simple and cheap way of doing the job and one where I can easily get hold of replacement fasteners if needed.
The parts I used are a total of 12 standard 748 / 9** fasteners & receptacles from any Ducati dealer.
You can get a set of 14 from Ebay for less than £40.
The two stainless brackets can be used but to be honest it will work without them.

Pull your fairing apart…remove the welnuts from the top of the centre section & the bottom of the lower section ( small plate & v-piece. )

Take the centre section & look at it from above… you’ll see the two tabs where two screws hold it on to the side of the bike. Now take your dremel and cut them off! You’ll need to finish up with something like the picture below.