| I would echo the same comments as above.
A P Reg 748BP would not have come with the curved exhaust heat shield as standard. You would have only got the smaller 'paralleogram' shaped alloy guard above the rearsets that bolts onto the lower (collector) section of the pipes.
These pipes are almost definitely off an SP/SPS version, but more importantly not off yours...
Not sure if it's relevant, but on most bikes I've seen, the cans slot internally into the collector section, whereas yours slot externally 'over the top' of the collector section.
Ditto the chip check comments, but apart from that no real problems with them
[Edited on 13-5-2003 by Guido] |