| whele, yes you can use a measurement between your subframe and wheel spindle centre. Or better still get a boss made to fit the wheel like I did it has a outside diameter of 40mm so I know for the centre reading I have to add 20mm, you can even use the bearing housing on the Paddock stand, in my case thats 52mm OD so 26mm to the centre, you only realy need the centre measurements if using a ride height tool, which I do use for racing when using different sprockets for different tracks., otherwise a measurement between the top of the bearing housing to your subframe should allow you to make adjustments, but these measurements will only truely apply to your bike.
if you want some comparisons between centre spindle & ride height tool compared to centre of spindle and subframe you could search the old notice board as I posted the info there a few months ago. Search by Skidlids or ride height.
Kev |