I knowe I'e mentioned this before , but here goes :
Well it looks like my worst suspicions were correct, the new underseat cowl on the rhs doesnt match up with the bolt hole on the frame. Its a matter of 5 mm or so, - worth , I think , further investigation (the lhs and All other mounts are fine).
As I've never pulled a ducati apart (and certainly cannot afford to pay someone else to) does anyone have any tips or guidelines to follow ? - I have the service manual but am left with the impression that this assumes prior knowledge.
Things I would like to know about are the necessary tools and if anyone has them (or could find them ) frame measurements , particularly from the swingarm pivot backwards (the manual is of little help here too).
I know it'll probably take a jig to be certain , but I'm not sure who in the UK may have one. The local Ducati dealers are , as always of little help (bar that of the horrendously expensive kind).
TIA
Wayne
