If you have a movement sensor make sure the led is off when you set the alarm. If it is permanently on then this is shafted (probably filled up with water through the sensitivity adjustment hole) and the alarm will bleep 4 times to say it already has a detection so will ignore it while set (or may simply go off continually depending on the fault). The beeping every 10 seconds sounds like you are putting it into its test mode. Do a search for Abletronics and Meta and you should find all this info on thier troubleshooting page. It is also in the installers/owners instrctions (well, was for the one fitted on my blade anyway). A bit late I know, but might help somebody. Cheers, John. |