Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 999 / 749 > Grey Swingarm Paddock Stand Bobbins

[jangol]

Hi,

had a look on here but not found anything that helps me @ the moment...

I have a Grey Swing arm 749 bp, I'm using a universal paddock stand with the rubber flat feet, it fits the bike ok, but im not 100% confident on it...

I know the later models (black swing arm) have holes ready for you to attach bobbins...

Has anyone every fitted any to a 749, i.e made holes up etc.... any pics did it work or is it a no no....

What else options do I have, so post back in 2005 mentioned using a single side swing up rear paddock stand??

Thanks in advance

JA

[Ghost]

Yes, I'll dig through and post a pic.
here you go.

[jangol]

Cheers Pal..
Be cool if you can stick a few notes on also around if it made any difference to balance of bike, or didn't you notice a thing?

JA

[Ghost]

Yes its very secure when on the paddock stand I use an aluminium Motrax stand with adjustable claws.

[jangol]

Is that a grey swing arm?

How did you fit them, what was used etc...

Thanks
JA

[Ghost]

Originally Posted by jangol

Is that a grey swing arm?

How did you fit them, what was used etc...

Thanks
JA

I prepared 2 lengths of aluminium bar of 20mm diameter with a 8 x 1.25 thread, 25mm deep. I then milled out the arm to accept the bar. as the arm legs are not symetrical one cutout is deeper than the othe, but just measure from the axle centre down.

I then welded the bar into place, lick of paint, job done.