Ohlins fork help needed-996RS

Jasper · 27-May-2013, 12:57

Hi,

does anybody know what the upper and lower fork clamp sizes are for these forks? I am confident the top yoke is 54mm. I just need to know if the bottom should be 56mm or 57mm!

I need to machine a set of Mag yokes to take them but do not have the forks to measure. The readings vernier I have been sent vary over 1mm which is not accurate enough!

Jasper · 27-May-2013, 13:04

some more pics:

Quarrybends · 30-May-2013, 05:04

Safest bet is to call uk importer or official ohlins agent, quote the model number as the RS could of been fitted with a multitude of forks. Spares are still available and I'm pretty sure the specs are too.

Jasper · 30-May-2013, 10:40

No model number mate. That's the problem.Hoping someone may recognise them.

skidlids · 30-May-2013, 17:19

The forks I have for my 955 are 54mm top and 58mm lower
I wouldn't trust the calipers in the pic, I was using a similar digital set the other day and they had a bit of a dead spot OK up to a certain measurement and then OK after a different measurement, but in between the two they were far from accurate, Dallas has probably binned them by now

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

30-May-2013, 05:04	#3
Quarrybends Registered Forum User Posts: 16 Join Date: May 2008 Safest bet is to call uk importer or official ohlins agent, quote the model number as the RS could of been fitted with a multitude of forks. Spares are still available and I'm pretty sure the specs are too. Reply

30-May-2013, 10:40	#4
Jasper Registered Forum User Ducati Corse Posts: 3,707 Join Date: Jun 2002 Location: YORK No model number mate. That's the problem.Hoping someone may recognise them. Reply