Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 999 / 749 > Racefit exhaust - any good?

[neilkeogh]

Where did you get your new end from?

I've been trying to get WSB one on ebay but they seem to have dried up for the moment.

[tricky]

Originally posted by neilkeogh
Nice can on a nice looking bike

I must try and fit mine this weekend

Thanks Neil.
Be prepared to turn heads in the street once the can is fitted. The burble from it is ace when you ease off the throttle.

[tricky]

Originally posted by neilkeogh
Where did you get your new end from?

I've been trying to get WSB one on ebay but they seem to have dried up for the moment.

the new rear was from http://www.spareshack.com
I think there is one on duccatinine.net aswell.

[neilkeogh]

cheers

[pj748r]

You couldn't do me a favour and measure the length of the can for me,would be most grateful and it would give you an excuse to go in the garage and look at your bike again and again again
thanks

Pete

[iang]

Neil,

Paul at DucatiNine is getting some of the wsb seats and sandbar apparently has them ( with discount )
They look brilliant with this exhaust ( see philips bike ) but they desparatly need your led rear light as the standard rear light is the only thing that lets it down as it hangs down like a hookers flaps

[RedMist]

Originally posted by pj748r
You couldn't do me a favour and measure the length of the can for me,would be most grateful ......

I would appreciate dimentions too - all this talk has got me thinking about a chrimbo pressy to myself, and relatively cheap too - compared to full set of Terni's!

[tricky]

Originally posted by pj748r
You couldn't do me a favour and measure the length of the can for me,would be most grateful and it would give you an excuse to go in the garage and look at your bike again and again again
thanks

Pete

I'm not at home at the moment but I should be able to get the measurements for you at the weekend.

[tricky]

Hello folks.

I managed to get out for a little run today and had a scare with one of them volvo's with the blue lights. Lookily it decided to leave me alone and go past me and stop a merc that passed me moments earlier. Been a bit cold today though, could have done with some thermals.

Anyway as promised I managed to get some dimensions of the exhaust for you.
The actual can is 35cm long and sticks out 4cm from my rear cowl. The link pipes are 25cm for the horizontal cylinder and 23cm for the vertical cylinder. Also attached is a close up piccy. (yes I know its needs a wash)

Tricky

[PHILLIP]

Hi all,
i have fitted a racefit WSB can onto a biposta with the standard rear sub frame and seat and the can sticks out about 5cm thats all, sorry i didnt take any pics, but is about the same as the pic attached, hope this helps anyone.
Regards Phillip OBBC

[Edited on 19-12-2004 by PHILLIP]