Can anybody recommend a brand of double sided sticky tape that is suitable for use on carbon bits and bobs?
I've got a key guard that I want to refit to my bike but the old sticky bits are beyond reasonable service but all the tapes I've come across have been too lightweight or to thick.
I've tried the carpet tape - B&Qs own brand though and it was bobbins. Tried sticky pads and they were to thick and left a gap between the carbon and the tank. I was after something like the stuff you get on tank protectors but I may have a stab at the silicone. I guess it comes off easy enough if it all goes tits up??
Clear Silicon Sealant every time, easy to put on, little or no raised edges, unlike sticky tabs, easy to position when putting on, easy removel of excess silicon & when you want to remove ir, easy to get off & clean up.
I used black silicone sealer. Coat the item you are mounting even and attach it in place . i then used lengths of masking tape to pull it to where it needed to be. When this sets you can clean up the edge with your thumb nail etc