Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > 748bp dyno run

[Nigel C]

90.4 bhp at the wheel 98.7 at the crankshaft at 10671 rpm .
blue flame cans sound awesome and the jhp chip is spot on for fuelling .

5bhp more than a bip with a full system on (not set up properly yet) and a second quicker than an 02 748r with the same cans but no chip in a 5th gear roll on.

i'm happy with that

11000 mls on the clock

[Edited on 16-1-2004 by Nigel C]

[antonye]

Not bad at all!

I'm looking to get mine spun up on a dyno at some point, so it will be interesting to compare.

[Nigel Booker]

nigel,
did you take into sussex rr? The last time mine was on there dyno it took 5 runs to get a printout, v-twins tend to knock there pc out.

[Nigel C]

yes Nigel i took it to sussex rr i think the pc crashed once and the first run was not so good as quite a bit of black stuff shot out of the exhaust near the rev limit, too much town riding had coked it up a bit i think, didn't happen on the second run .

oh i will get the chip puller back to you asap maybe after sussex meet on sunday but the forecast is frost and ice and i don't fancy my chances down that hill at the entrance to you road

[PeteB]

Faster than an 02 R in 5th roll-on.

That'll be down to the gearing; must remember to stay in a lower gear when chasing a bip then!!

[Nigel Booker]

Nigel,
no rush for the chip puller.

BTW I wouldn't ride down the long furlong road or the entrance to the builders merchant at the moment, thats the entrance/exit to the council yard and the gritters have been out since 8pm so its covered in salt.

[rcgbob44]

No!............................I`d better not say anything