Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > Single seat fitting ...

[the phantom pieman]

Finally got hold of a single seat unit from e bay ( genuine ducati ... but I think the pinstripe paintsprayer must have been ****ed ... or Daytona did it themselves!)

Come to fit it and finally realise that you need diff brackets ... or the lock etc. The Bip seat obviously drops down so a) The fight mounting bracket is to low ( but reversing this could work.) But to doesn't alter the fact that the locking pin will be way off ...

Can anyone technical tell me what parts I need? As I will have to go into a local dealer and order in german !!
#
Vielen Dank

[Totto]

Check this site out , hope it helps !



http://www.gastric.com/toys/ducatibip2mono.htm

[Edited on 16-10-2004 by Totto]

[the phantom pieman]

Thanks ... that should about cover it ... good tip re the bolts ? copper grease and leaving them in place ...