Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > SPS Carbon heat shield

[PDL]

What do i have to do to get this heat shield to fit my 748 Bip?

http://cgi.ebay.co.uk/Ducati-748-916... cmdZViewItem

Is it different down pipes or can I get a bracket or something?

[KeefyB]

You can get a threaded bracket that fits around the exhaust pipes.I bought one for my 996 and got the bracketss in the packet.I think they are available separately.
I may still have one or two kicking around in the garage.

[Edited on 27-10-2005 by KeefyB]

[Whele]

somebody has got to say it

Buy a 996SPS

[PDL]

Originally posted by Whele
somebody has got to say it

Buy a 996SPS

Eventually that is the idea but also keeping the 748, but at present my budget and marriage will only stretch to a heat shield.

[aka.eric]

Ive got this one,its used but in good condition, a couple of small chips on the front edge,with the clamps for standard pipes.Came from Rip so its good quality carbon.£20 if its any use to you.

[PDL]

Sorry aka.eric only just seen your post. You have u2u.

[deej]

eric if its still available i'll take it off your hands if it will fit 50mm termis

[aka.eric]

Sorry,Desmo had it.The clamps were for 45mm system.The Termis I fitted had the brackets welded on the pipe,this type of guard is no good as the hole centres are different.I used a standard 998 aluminium guard,the carbon one was no longer available.