Problems With Slipper Clutch I recently bought a Bucci Clutch on ebay The clutch disks were not the same from the instructions, but since I have some spare clutch disks I used them to obtein the instrutions disks compilations. The problem is that when starting to move the bike, in a low engine rotation, every thing is fine, but if I rev the engine to 3500 rpm or more, at firts every thing seams fine, but then the bike jumps a lot and squils - makes funny noises - (sometimes it iven stalls) and finally stops the jumps and rolls ok. I tryed a lot of thing to try to stop this: - i've sanded the iron disks - I add another iron disk to obtein a 38mm thick group of disks but It keaps doing the same. Every thing else is ok. The slipper clutch is work well when I Reduce gears and while rolling, the clutch is smooth like it sould. Please try to gide me trough this problem |