Ohlins to 888 Srada

pibbow · #1 05-Jun-2006, 20:06

As a few of you have compleated this conversion I would like some advice. Can you still get the one to fit stright into the standard yolks(not sure of the spelling) or do I have to get special stuff machined. Can I use the standard calipers. Any info would be great.

Cheers Peter.

Nattyboy · #2 05-Jun-2006, 21:04

Hi mate - got your message but im just running std showa forks..

Nat

Rob B · #3 07-Jun-2006, 08:50

You'll need to getthe top yoke bored to fit the bigger Ohlins and the bottom is smaller so that'll need an SP bottom yoke or shims. That's it.
Rgds, Rob

pibbow · #4 07-Jun-2006, 11:05

Hi Rob is it as simple as that?

Rob B · #5 07-Jun-2006, 15:13

Yes, except some 51mm clip-ons but I do have a spare set of nce black, high shine anodised ally ones in the loft....

pibbow · #6 08-Jun-2006, 11:09

OOOOOHHHH suit's me sir how much for da clipons Mr?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
		Use Vertical Postbit