Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > Monsters > S4r rad protector

[Lee1980]

Finally made one, similar to nattys but silver and i wedged it between the ends instead of taking off the fans to bolt on

4 zip ties secure the corners incase it works loose, seen someone else use them on a rad to as theyre nylon hope they dont melt.

I like it what u think? Im also thinking of some trim to finish off the top and bottom of the mesh. If anyone else attempts it wear gloves to as my hands are cut to ribbons

Got some smaller diamond mesh for the oilcooler to do tommorow

[Paul996]

Lee

Looks good, where did you get the mesh.
Might give it a go to protect the rad

[Lee1980]

B&Q is your friend 25x50 cm sheets i think or they have big ones, i got one bigger diamond for the rad and a smaller diamond for the cooler which u will see tommorow once my fingers have healed

I made it wedge between slot in ends of rad just cut till it went in, and held with zip ties plan to do same with cooler

[Albie]

Must just nip out to B&Q

[Lee1980]

And heres the oil cooler ,

Remember kids wear gloves as i have about 10 cuts now

[Lee1980]

and heres them both, in one pic

[LesPaul]

Not the best pic but here's mine, did it a couple of months ago

Darren

[Mr C]

What have you tie rapped it too?

[Lee1980]

On the rad it is wedged wetween the ends and held at each corner with a tie by passing it thru the gap between the last fin and the rad ends.

On the oil cooler is simply wedged in not fallen out yet

[berto]

:P Looks good Lee just a wee question....did you have it on your front tyre cos you don't seem to be bothering the edge of the tyre(s****** s******)no offence!!