Cam Holding Tool

r15suk · 07-Mar-2014, 22:52

I got a cam holding tool for my belt change, but the instructions only say that you need to use it on the vertical belt.

Why is that?

Many thanks
Simon

skidlids · 07-Mar-2014, 23:20

It's because the Exhaust cam on the rear cylinder keeps springing back due to where it sits on the cam

The front cylinder isn't sat in the same position

r15suk · 08-Mar-2014, 12:05

Thanks all understood now

Simon

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode
Postbit Selector
Use Horizontal Postbit

07-Mar-2014, 22:52	#1
r15suk Registered Forum User Mille Posts: 180 Join Date: Jul 2010 Location: Reading Cam Holding Tool I got a cam holding tool for my belt change, but the instructions only say that you need to use it on the vertical belt. Why is that? Many thanks Simon Reply

07-Mar-2014, 23:20	#2
skidlids MotoGP God Posts: 18,274 Join Date: Apr 2002 Location: Oxford Mood: Its ONLY a Bike Club It's because the Exhaust cam on the rear cylinder keeps springing back due to where it sits on the cam The front cylinder isn't sat in the same position Checkout the Desmo Due Paddock on Facebook Reply

08-Mar-2014, 12:05	#3
r15suk Registered Forum User Mille Posts: 180 Join Date: Jul 2010 Location: Reading Thanks all understood now Simon Reply