Ducati Sporting Club UK > Model Specific - Discussion, Technical Problems and Help > 998 / 996 / 916 / 748 > MT940B1 Dash

[DAVEST205]

Managed to get a Marelli MT940B1 dash (CS-600 kit) installed today, upon turning the bike on, wry thing appears to be ok other than no rpm figure is displayed, I've not tried riding the bike yet so not sure if speed will be showing correctly either as its showing '5' at standstill.

Anyone with this dash installed, does the rpm and speed need configuring, does anyone happen to have a copy of their settings for rpm and speed.

The opening screen shows 'Ducati DL2.9) then 'NOTPRO'...

Thanks

[skidlids]

Yes Speed will need configuring and I suspect the rev counter will as well as it would differ between a bike with a P8 ECU and one with a 1.6M or a 59M ECU

[DAVEST205]

Cheers skidlids, I'm using the front brake disc bolts so presuming I set this to 12 pulses, will have a dig regarding the rpm pulses.

Ta

[skidlids]

Originally Posted by DAVEST205

Cheers skidlids, I'm using the front brake disc bolts so presuming I set this to 12 pulses, will have a dig regarding the rpm pulses.

Ta

Yes 12 pulses, i did an article for Pronto about it a while back

Here is the summary

Summary: -
From my findings you don't need a special trigger ring and the trigger points do not have to be evenly matched.
Use Allen bolts as disc fixings and as trigger points, these will generate 12 pulses per rotation.
For a 120/70/17 Pirelli tyre use an input figure of 10344 for MPH speed-readings.
For a 120/70/17 Michelin tyre use a figure of 10427 for MPH speed-readings

I also have PDF copy of the manual if you don't have one, if you need it just send a email request to skidlids@ntlworld.com

[DAVEST205]

That excellent mate, will try that later.

You have mail also.

Thanks