Old thread ressurected here, but my bike just failed the MOT on headlight adjustment (and damn exhaust stamping). My black knobs don't do anything, it's like they're not attached to anything inside the light unit. And yes i've tried turning them loads and loads x 10 times.
It's almost like the thread's have come off or stripped - is this possible? Is there anything I can do to re-attach them? (it's a 2004 749s)
Old thread ressurected here, but my bike just failed the MOT on headlight adjustment (and damn exhaust stamping). My black knobs don't do anything, it's like they're not attached to anything inside the light unit. And yes i've tried turning them loads and loads x 10 times.
It's almost like the thread's have come off or stripped - is this possible? Is there anything I can do to re-attach them? (it's a 2004 749s)
Clearly going to wrong garage if they are fussy about a stamp, my 749r passed with Termi .... tester said it made it sound "right"
Yeah but most of 'em are stamped 'FOR RACING USE ONLY'.Mr.MOT tester cannot ingnore that.
Get a really good welder with a tig kit, run a flat neat weld over the "For Racing Use Only", then run a similar weld down the other side of the can so they match. Clean up the welds with a scotch bright pad ..... sorted.