PDA

View Full Version : power graphs std and modified

andyb
24-Jan-2005, 20:29
std 03 999r
andyb
24-Jan-2005, 20:31
see how up and down that is compared to this....
electricsheep
24-Jan-2005, 20:34
That looks great, now i am waiting for my magic session to come arround

[Edited on 24-1-2005 by electricsheep]
andyb
24-Jan-2005, 20:37
hopefully a bit smaller size...
khu996
24-Jan-2005, 20:43
Those power and torque curves look damn smooth, I can't wait...roll on February 8th!

My 749 will probably make 50 odd horses less, but if they're as well delivered as that, I'll be a happy man!
andyb
24-Jan-2005, 20:44
Wot you having?
khu996
24-Jan-2005, 20:52
Im just having the asymmetric system and PCIII set up by John, it'll hopefully cure the woolly response and little amount of backfiring it has at the moment.

I spoke to John last week, and Ken booked me in today. Like you said...where else do you get the kind of service that JHP offer?! :D
electricsheep
24-Jan-2005, 21:01
I am booked in a few weeks after you so I would like to see the results
khu996
24-Jan-2005, 21:05
No problem, I'll scan the graphs when I'm back and post the (happy) results :D

I'm not bothered about maximum power, I just want a fat and flat monster torque curve :P
dickieducati
24-Jan-2005, 22:59
ooooooh, i got one just like that.

dotted line is pre power commander and set up.
madmav
24-Jan-2005, 23:02
i'ts amazing what you can do with computers:lol::lol::lol::lol::lol::lol:


Graphics:smug:
khu996
24-Jan-2005, 23:05
Sweet. We could have a new section devoted to dyno graphs.

Oooo...yours looks nice, what do you think about mine.....do you think it looks too big on the end?!? :D :lol:
Jon
24-Jan-2005, 23:31
Andy, didn't you say you had 150bhp?
dickieducati
25-Jan-2005, 10:11
very similar curves and mine actually seems to have a bit more power and torque low down and eqivalent peak torque just losing out on peak power by a couple of horses. not bad considering mines only a 999s with 54mm system.

looking forward to getting my m620 done; the power curve should fit nicely under the torque for the 999! :lol::lol::lol:

[Edited on 25-1-2005 by dickieducati]
andyb
25-Jan-2005, 22:20
Yes that was my poetic licence after a conversation with john without the paperwork to hand.

Dickie, when you look at std 999s 999r its 136 and 139 anyway. So there as near as damm it.