"R" panel Question

[Green1]

Will standard 999 side panels fit with a R type nose !

[JPM]

Pass... The R nosecone is supposedly wider, but surely the frames etc are the same, in all honesty I don't know, be interested to know the answer

[Ducnow]

I want to be sure about that also.
Anyone?

[dave w]

A £10 says there the same ;)

[bolds]

They should do but if they are pre 2005 the bits at the back of the panels will have to be cut shorter to clear the box section type swing arm

[Ducnow]

Originally posted by bolds
They should do but if they are pre 2005 the bits at the back of the panels will have to be cut shorter to clear the box section type swing arm

Hmmm.... you may have a point there.

[yellowisfriedegg]

No , the standard panels have a separate black plastic air scoop cover , on the R the top of the side panels which covers the air scoops is all one bit left unpainted carbon , it has a small lip which locates on a tab on the bottom of the top fairing at each side , as JPM said , the top fairing on the R is also wider so you will have a mismatch :(

The lower rear of the panel is the same though , the swing arm difference only affects the underside turn of the exhaust.

[bazzer sps]

Well i managed to fit 03 999s side panels to my 04 999r (box section swing arm) without to many problems.I did have to use some spacers to miss the swing arm and remove the plastic air intake cover (3 screws) to fit to the standard "r" front panel although does not look preety but for track day bodywork who cares,i'm fortunatley however to have an 03 front panel as well so dont have to remove the plastic air intake covers if i put the complete bodywork on.
I hope this helps

[butch890]

get your tenner out Dave!
Butch

[Green1]

Thanks all , will let you know the out come.

Have ordered skidmarx's side panels impregnated red, with a black impregnated belly pan.

[JPM]

As a side note, I was told yesterday that Ducati currently aren't manufacturing 999R carbon panels.

I believe they don't make 996R carbon panels anymore either, just the 998R

[yellowisfriedegg]

Originally posted by Green1
Thanks all , will let you know the out come.

Have ordered skidmarx's side panels impregnated red, with a black impregnated belly pan.

why don't you just get a matching upper fairing too , after all it's the first thingthat hits the ground and the standard carbon upper fairing is just shy of £1k , why risk it ? :rolleye:

[dave w]

Originally posted by butch890
get your tenner out Dave!
Butch

:P:P iIf i had a tenner :ninja: