Oil pressure sensor mount - MT940

[DAVEST205]

Managed to get hold of the additional oil kit for a marelli MT940 dash and I'm looking for a particular part to mount the sensor to the frame.

On the pic below its the white plastic 'pipe separator' type piece if you follow the oil pressure banjo hose up to the vertical frame, I'm sure I've seen these advertised before but for the life of me cannot find anything similar.

Does anyone know where I could find one or something similar...

http://img.tapatalk.com/d/13/09/01/epara3at.jpg

[antonye]

I think I may have one Dave - need to check it is the right size for the frame but you can have it.

PM me your address and I'll pop it in the post for you if I can find it!

[DAVEST205]

Thanks Antonye you have pm :)

[antonye]

It's bigger than I thought! I'll stick it in the post anyway.

If it's no good, you can try searching ebay for "pipe clip double" as that throws up a few things like this for a couple of quid:

http://i.ebayimg.com/t/Plastic-Double-Snap-In-Swivel-copper-Pipe-Clip-15mm-22mm-15x22mm-Diff-Qty-/00/s/NDAxWDYzMg==/z/z68AAMXQLs5RuZKv/$(KGrHqYOKp0FG3J-nhzMBRuZKu5eBw~~60_12.JPG

and this...

http://i.ebayimg.com/t/FIX8Q-10mm-GREY-DOUBLE-PIPE-CABLE-CLIP-FIXING-CAR-x12-/00/$(KGrHqUOKj8E19L36O,NBNuvPsnplg~~_12.JPG