916 Ride height

[dst1]

God I am such a Numpty, while playing at being a bike Mechanic on my 916 I have lost about an inch in rear ride height.
This is all down to me trying to fit front and rear sprockets
and trying to understand that adjusting hub thing at the back end, god I miss my ST2.
Do I have to keep turning the adjuster untill the height comes back or what....Help...I am foooked...:puzzled:

[dickieducati]

im probably as much of a numpty as you but when i watched someone set up my monster, with an adjustalbe ride height bar, that is exactly what they did. just wound it out until they got the height i wanted.

[bradders]

contact harv748 - he sells a tool for that..

[keefer]

sounds like you have wound the eccentric hub round too far.
you need to have the sprocket bolt in the lower half of the adjustment

[dst1]

If I re-adjust will I get the ride height back or will I have to use the tie rod...?

[keefer]

if you have changed the amount of teeth and chain length then yes you will need to make adjustment to the ride height adjuster.
but as I said in the post above make sure you don't have the hub in the upper position or you will be chasing the impossible

[Edited on 13-1-2006 by keefer]

[dst1]

Many Thanks Keefer...:D

[andyb]

sicfth munts agu, i cooount evun spel injuniirr!:lol:

Now I arrr wun!

[Harv748]

dst1...read the thread below and drop me a U2u..all will be explained...

http://www.ducatisportingclub.com/xmb/viewthread.php?tid=16584:sing:

[Edited on 13-1-2006 by Harv748]

[dst1]

The penny has finally dropped and I have sussed out how to use that bloody hub adjusting thing....:D

14 tooth sprocket on front 37 on rear and a renthal carrier.

Just need that ride height tool from Harv748, u2u sent.

Hope I can figure out how to use it...:lol:

[m1keyp]

DO NOT forget that one end opf the ride height rod is reverse threaded:saint: