749 54mm termis, clearance to 2004 swing arm?

[749er]

Hi
anyone got any photos they could mail me showing the gap between the pipe and the swing arm. Have got about 3mm, seems a bit tight, and I had to jiggle the end can into place. Am a bit worried it not quite set as it should be, and maybe under a bit of tension. Dont want it splitting. Any tips, phtos etc much appreciated

cheers

D

[andyb]

They are all like that sir.....................try it with a 57mm!!!!!

[Gizmo]

Originally posted by andyb
They are all like that sir.....................try it with a 57mm!!!!!

57 = fag paper or a slightly smoother and more silvery swingarm on the weld :D :D I'd take photos but there is no gap to see.

54, should be easy, 3mm is loads of clearance :) watch the lower rear right hand fairing don't touch the pipe, it melts the fairing :D

[749er]

Originally posted by Gizmo
Originally posted by andyb
They are all like that sir.....................try it with a 57mm!!!!!

57 = fag paper or a slightly smoother and more silvery swingarm on the weld :D :D I'd take photos but there is no gap to see.

54, should be easy, 3mm is loads of clearance :) watch the lower rear right hand fairing don't touch the pipe, it melts the fairing :D

sounds like a challenge to me!

[Real McCoy]

just smack the pipe with a brick, there'll be loads a room ;)