Wanted, monster top yoke

[final_edition]

Looking for a top yoke for a Monster S4 (same spindle nut as 916 etc)
After one with the provision of fitting Renthal bars, so one with clamps.

Have the standard S4 yoke to trade, which has been machined out to 53mm (Ohlins) and outside lugs taken off, for clip-ons,If needed.

Thanks,

Andy

[Iconic944ss]

Hi There,

I know of a brand new OEM S2R top yoke here:

http://www.ebay.co.uk/itm/Ducati-Steering-head-for-Ohlins-forks-53mm-96843403B

But I'm not sure how much use it is to you.

As an aside, who did your machining work for you please?

Regards - Frank

[final_edition]

Thanks Frank, can't open the link due to location of pc. Will look in the morn.

I machined the yokes out. on a lathe with a face-plate. Hmm, was it 53mm for Ohlins top, or 54? It's now big enough for Ohlins, rather than Showas.

[final_edition]

Not listed anymore:(

[skidlids]

for the 748/916/996 etc Ohlins its 53mm top 56mm bottom where as the Showas are 53mm top and bottom
I have Ohlins road and track forks sat in my Monster yokes without any modifications as the forks came from a early Yam R1

[Iconic944ss]

Sorry about that - auction must of ended but they did relist:

www.ebay.co.uk/itm/141191912155

Lets see if a piccy will tell a ....

http://www.forza-moto.com/upload/photo/orig_img-8014-54.jpg

[final_edition]

ooh, ta.

The monster S4 top one was 50mm. I machined it out for 1098 Ohlins

Kev, looking to use monster yokes to keep the 30mm offset.

Might bite the bullet and go for IMA yokes :eek: