Clutch torque settings

[tsmales]

Hi, how tight are the bolts holding the pressure plate supposed to be ? I've looked in the manual but all it says is
"insert a spring and cap in each hole and secure with screws at the specified torque"
Any suggestions, please ?:puzzled:

[nelly]

not much at all ;) 6Nm if I recall. Bottom them, handtight then just give them a nip. Copaslip them before refitting to make future life easier to :)

[tsmales]

Thanks Nelly, When you say bottom them do you mean all the way (handtight) ?

[rockhopper]

They snap very easily, screw them in all the way then just nip them up with a short allen key.

[tsmales]

Thanks a lot :sing:

[moto748]

A Ducati mechanic once snapped one of the "turrets"off my clutch hub by over-tightening!

Still, I got a free clutch under warranty! :)

[tsmales]

Thats it then, Fairing back on in the morning and fingers crossed for some dry weather :sing:
Thanks for the help.