View Full Version : Custom made washers, where from?
Tonio600
26-Apr-2009, 14:26
I need some custom made washers so that I can easily swap from a 620 rear wheel to a 600 one on the Monster. Dimensions should be 17mm ID, 24mm OD and 2mm thick. Well OD does not matter too much actually.
Any idea where I can source such bits?
Chris Wood
26-Apr-2009, 14:42
Rich Casmore? Doesn't he run a fastners business??
rich-racing.co.uk
27-Apr-2009, 10:29
you'd need to know somebody it the trade....:rolleyes:
stock 16mm washers will have clearance on, 2mm thick but smallest OD standard is 30mm.
can you get by with this?
24mm - 17mm = 7mm. half of this either side 3.5mm. not much of a washer..
remind me of your address and I'll fix you up.
Tonio600
27-Apr-2009, 13:25
Hi Rich,
Thanks for your offer of help mate.
Indeed, they're more spacers than washers but a fellow ducatisti offered to make them for me. I'll PM you my address anyway for another business we had to finish ;)
Cheers,
Tonio.
rich-racing.co.uk
27-Apr-2009, 13:48
Rich Casmore? Doesn't he run a fastners business??
running it into the ground.......:(
Hi Rich,
Thanks for your offer of help mate.
Indeed, they're more spacers than washers but a fellow ducatisti offered to make them for me. I'll PM you my address anyway for another business we had to finish ;)
Cheers,
Tonio.
If they are spacers I should be able to turn those for you just need a bit of a drawing with dimentions.
Tonio600
27-Apr-2009, 20:47
Thanks for the offer Chaz, but a fellow Ducatisti is already on the case :)
vBulletin v3.5.4, Copyright ©2000-2025, Jelsoft Enterprises Ltd.