Help with socket size
 

Can somene confirm the socket size for the rear nut that holds the hub in place, and also the torque setting to do it back up..just off in to town in a bit to buy a couple of new tools.

ta!

Nat

Nat i think that side is 41mm ?? maybe wrong though, i know the other side is 46mm?? hows it going mate, just back from job.

nat
 

Yep the sprocket side is 41mm,

41mm and 157Nm

41mm and 46mm ..

Thanks guys...nipped into Halfrauds..."ooohh..we dont do them that big sir.."..:mad: Guess i'll have to track down a tool supplier in the week..

Nat

Thought a few people on here said that Halfords 3/4" pro range went up to 46mm.

They also crop up on e-bay ... 1 or 2 very expensive, odd bargain if you have a good look.

oh yeah, forgot...................... Halfords don't sel them. You'll need to find a tool supplier :lol:



sorry Nat, couldn't resist. End of week wind down :)

Your not helping young man...:P - You been at the stellas already ??!!

Nat :lol:

Nat go to Beesleys tools, its just across the road from Kwik fit, and the Shell garage, I got the 46mm in there and the 3/4 to 1/2 adaptor, so you can borrow either of them if required. They stock all the over sized range in the shop, so don't have to order....;);)

not yet, but i'm practicing a deep mental preparation in readiness for the onslaught in about 2 hours time :)

"Tomorrow Cat, ................. I'll mostly be hungover" :lol:

Halfords do sell a 1"13/16" = 46mm hub socket, 1/2" drive most tool suppliers will be 3/4" drive.A 3/4" drive torque wrench aint cheap!