Ducati Sporting Club UK - View Single Post - New cams

Mr_S · 09-Mar-2005, 21:25

I asked the same question during my head rebuild, the answer was no running in required.

The bikes already been on the dyno for 14 high speed full rev runs to setup the fuelling etc for the cams, and this is harder than you'd normally run it.

09-Mar-2005, 21:25	#3
Mr_S Registered Forum User Big Twin Posts: 1,324 Join Date: Mar 2004 Location: Gosport I asked the same question during my head rebuild, the answer was no running in required. The bikes already been on the dyno for 14 high speed full rev runs to setup the fuelling etc for the cams, and this is harder than you'd normally run it. Reply