| Seat unit is attached using Dzus fateners and will be fitted with a nice thick bit of foam to help me stretch over the tank and reach the Clip-ons.
In this pic it can just be seen that the seat didn't quite match the subframe I made it sat on it at the edges but the underside of the seat has a curve that created a gap.A good squirt of expanding foam soon sorted that out, so now I am working on the engine breather catch tank, the originals are still in place although I have turned them up side down and mounted them on top of the bikes original subframe and into the gap under my fabricated seat support, now I just need to drill a hole in the right place and pipe it to a 500ml bottle.
[Edited on 21-4-2005 by skidlids] |