Quote:
Originally posted by chris.p
Quote: Originally posted by HW
As many of you will know. I was responsible for butchering a Race Products belly pan to make it fit on my 749S.
Those nice chaps at RP sent me another one so I could try again, and this time I have made it fit with only a few minor mods.
I have still had to cut a slot in the bottom for the exhaust, but I can see that the fibreglass has "slumped" along the bottom and hardered like that so if it was in the intended shape it would have been OK. I cut a slot for the sidestand this time instead of hacking a section away, having measured the dimensions of the original one relative to the floor and the rear axle.
It is still a bit tight around the oil cooler, where the Dzus fastener rivot touches, but it is possible to get it all together.
[Edited on 6-5-2005 by HW] |
Once you are happy with what you have done, why not pop it down to dave at H.C.Racetech ( just outside lincoln)
http://www.hcracetech.co.uk/
He will make a mould from it & hey presto you have a replacement that will fit first time
Chris. |
GOod idea. Not heard of them .... I'll make a not though.