Kev, the ie ones wont work because the signal from the transducer ignition relays is different to the normal type of signal. I put a 900ssie on our bike & even tho it read a signal - it cut the rear coil out completely, so was only running on one cylinder. Even the dyno revcounter wont pick up the signal from the ignition relays (transducers) I'm sure you need the early type rev counter fitted to the 900 carbed bikes to get it to work properly. I also brought a shift light (L.E.D) unit & found I couldnt programme it, cos the lights just came on & stay on... more money out the window, but was a good idea & the salesman at Alli-Palli assured me it would work (dont they all?) but after cutting the wires to fit - I could'nt send it back. Am still on the case. Alan |