| Not sure it's applicable but the factory 999RS manual recommends (from the crankcase outwards):
Fit the set of clutch plates (18) in the following order:
- 1 sintered plate (A);
- 1 convex plate (B) (convex side facing outwards);
- 1 sintered plate (C) ;
- 1 flat plate (D) (1.5 mm thick);
- 1 sintered plate (E) ;
- 1 convex plate (F) (convex side facing inwards);
- 1 sintered plate (G) ;
- 1 flat plate (H) (1.5 mm thick);
- 1 sintered plate (I) ;
- 1 convex plate (J) (convex side facing inwards);
- 1 sintered plate (K) ;
- 1 flat plate (L) (1.5 mm thck);
- 1 sintered plate (M) ;
- 1 convex plate (N) - (convex side facing outwards) ;
- 1 sintered plate (O) ;
- 1 flat plate (P) (1.5 mm thick);
- 1 sintered plate (Q) ;
- 1 flat plate (R) (2 mm thick). |