Chaps - help, I am in need of some advice ASAP as I am leaving for France next Thurs.

I have recently fitted a pair of Termignoni exhausts to by BP (45mm). I left the original BP chip on the bike for a week before I got round to installing the specific Termis chip. The bike ran fine on the BP chip, no problems whatsoever.

As soon as the chip was replaced, I immediately noticed the loss of power in first gear for half a sec, which I did not get with the BP chip.

Now when starting off in first gear I have rev the bike more than usual before I release the clutch for fear of stalling.

This happened to me a few times last night, drop down into second, pulled into a Pub...stall. Come out of a T-Junction, as I would normally....stall. What's going on??

Advice seriously appreciated. I am thinking about refitting the original BP chip on the Termis cans and wait until I get back from France.

[Edited on 15-8-2003 by thrustercat]

[Edited on 15-8-2003 by thrustercat]