Replacing a clutch is very simple and only requires a hex wrench to remove the cover and a hex to remove the spring retaining bolts. Once the springs are off, the pressure plate is pulled off and the clutch plates can be removed. Be sure to note the order that they come out so the new unit can be installed the same way. There is a good chance that the steel drive plates can be sanded and reused (measure the thickness to verify they are in spec and are flat). Measure the friction plates as well. I suggest that you pick up a Haynes service manual or download the appropriate information from the ducati.com website. Let me know if you run into any problems and I'll be happy to walk you thru the procedure. My e-mail is:
marty91698@yahoo.com