Recently I removed the P8 unit from my 916SP to see what kind of chip it has installed. 5 minute job, and all back together again.
Now the bike won't start! It turns ove fine, and the fuel pump primes etc...just appears to be no spark.
What have I done
In the dreaded haynes manual, it states that the power module relays on early model 916's have internal fuses...I'm wandering if I have blown these somehow when removing/installing the unit? Where are the fuses on/in/around these relays? I can't seem to find them!
There is one fuse that is part of the wiring loom near them (which is not blown)...is that it?
Any ideas?