[yeti]

Originally posted by bike mad
when you do the last layer the joints should go against the slope,
but the important bit is to get a good seal on the joints, it's done by melting the edge of the felt, ps when I say melt whot I mean is you put heat on it till it goes soft and the surface starts to run, I have found that you need a lot of heat as its a large area and the felt cools down fast, take my advice and hire a large gas powered heat gun, and keep it on the move as it will burn the out side of the felt and not have time to soften the center,

Guess what I'll be doing this weekend................

Didn't really want to play with my new toy