As you're an engineer it should be simple. The switch is either open circuit or closed circuit when the stand is ip or down so, you can do 1 of 2 things:
1. Jumper the switch out.
2. Or cut the circuit.
There's no need to pay any money. What ever you do, use some black heat-shrink wrap to ensure that water ingress in prevented.
Quote:
Originally posted by badmanners
Hi,
have seen a few posts recommending the side stand bypass modification but cant seem to find any instructions or diagrams in the forum.
Other than pay for the instructions on Ebay (£6.50)
or
putting up with disconnecting the side stand switch without it cutting out when placed in gear,
I am at a loss.
Can anyone help?
PS
I have seen the kits from dealers and shops but I am
a: a yorkshireman
b: an engineer
2 good reasons to DIY  |