I added a load of stuff on this and other SBK electrical problems ,
here its worth a read but can get technical
if you get stuck one of the contibutors to that, Derek, is up your way and would probably lend a hand.
Quote:
Originally posted by minty70uk
Anybody help? My damn 916 has developed an electrical fault the Reg / Volt 3 amp fuse blew Friday causing it to break down, got a replacement delivered to roadside which lasted about a mile anyway managed to get home in the end. According to the Haynes manual this is the fuse for right handle bar switches hence kill switch but it also goes to regulator / rectifier. Traced all the wires through the loom and as far as I can tell they and the connections look ok. The bike is a 1995 Biposta with only 7500 miles on it, bought off the original owner last summer hence it is like new. When I bought it I was informed that it had a heavy duty regulator / rectifier fitted by Alvins of Aberdeen under warranty not sure whether this helps in finding the problem. Whilst I was looking around the large heavy duty 30 amp charger fuse looked in extremley poor condition hence held by a thread. I will replace this but just after a bit of advice really. |
[Edited on 3-5-2006 by Gizmo]