| Frank, I'm only guessing at what you mean as the image didn't show up, but maybe your headers are not centred, or they're not mating fully at the join behind the engine causing the downpipe from the rear cylinder to be twisted/rotated slightly..just guessing. The pipes should be aligned at the indicators, for sure. Of course your cans could be asymmetical, just like mine: My Sil Motor hi-level cans have completely different curves. And they're almost 20mm too short for the hangers they come with so that they don't seat properly and wobble about. The seal is bad so I have to gob it up with ally tape and small animals. Folk say Sil Motor are top quality but I'm not impressed. But I've lived with them for 2 years. Bah. |