| Oh if only it was that easy......
The removal of my swingarm bolt invloved all of the above , then an even bigger hammer , some screwed rod , large washers and nuts for said rod, a hacksaw blade (no hacksaw just the blade!) , and finally a large drill and 19mm drill bit!!!
Then a Ducati Technician to remove the bearings etc from the swingarm too.
Now i really hope you don`t have to go to these lengths , to say i was upset is an understatement , and all on a bike with 5000 miles.
Lesson learnt , grease the bolt , grease it again and finally chuck some more grease at it.
Gav |